Required Tools; Table 2-2. Required Tools - Emerson FB2100 Instruction Manual

Emerson FB2100 Flow Computer Instruction Manual
D301783X012
March 2019
Table 2-1. Environmental Specifications
Specification
Ambient
Temperature
Humidity
Vibration
2.3

Required Tools

Certain tools and equipment are required for installing and servicing the flow computer.

Table 2-2. Required Tools

Tool
Torque wrench
2.5 mm hexagonal wrench
High-wattage soldering iron and solder
#1 Phillips-head screwdriver
#2 Phillips-head screwdriver
#3 Phillips-head screwdriver
1/8 inch flat-head screwdriver
7/32 inch flat-head screwdriver
Utility knife
Wire cutters
Wire strippers
Laptop PC running Field Tools with FBxConnect
configuration software
12
Configuration Aluminum Enclosure
No battery, C1D2
No Battery, C1D2,
Relay installed
Lead Acid Battery,
C1D2
ATEX/IEC Ex nA
No Battery
5% to 95% non-condensing
2g over 10 to 150 Hz; 1g over 150 to 200 Hz
Range
40°C to +80 °C
(-40 °F to +176 °F)
-40 °C to 60 °C
(-40 °F to 140 °F)
-40 °C to 45 °C
(-40 °F to 113 °F)
-25 °C to 55 °C
(-13 °F to 131 °F)
Use
For bolting/mounting the flow computer
For manipulating rotation set screw
For tinning ground connection wire
For screws on HMI module
For screws on other modules and boards
For optional aluminum enclosure clamps
For 5.08 mm pitch terminal block connections
For installing external solar controller
For installing external solar controller
For installing external solar controller
For installing external solar controller
For software configuration
Fiberglass Enclosure
-35 °C to 80 °C
(-31 °F to 176 °F)
-35 °C to 60 °C
(-31 °F to 140 °F)
-35 °C to 45 °C
(-31 °F to 113 °F)
-25 °C to 55 °C
(-13 °F to 131 °F)
Installation