Chapter 2. Installation; Hazardous Locations; Required Tools; Mounting The Chassis - Emerson FB3000 Instruction Manual

Chapter 2. Installation

This chapter covers the following topics:

Hazardous Locations



Required Tools



Site Considerations


General Wiring Guidelines

Grounding


Mounting the Chassis


 Removing the Battery Saver Tab
Connecting Power

Removing the I/O Cover

 Connecting Communications Ports
2.1 Hazardous Locations
For North America the FB3000 has certifications for Class I Division 2 (Groups A, B, C & D) non-
incendive and non-hazardous locations only. For other world areas the FB3000-has ATEX and IEC Ex
certifications for Ex ec Zone 2 non-sparking installations and non-hazardous locations only. his is
body text.
All certifications are listed on the data plate located on the top of the device. Refer to the CSA
Approval Information document (CD9411) for special information for Class I Division 2 and Ex ec
Zone 2 installations.
2.2

Required Tools

The RTU ships from the factory fully assembled.
Certain tools and equipment are required for installing and servicing the RTU.
Table 2-1. Required Tools
Tool
#2 Phillips screwdriver
¼" slotted blade screwdriver
Magnets
Non-metallic tool
Laptop PC running Field
Tools™ with FBxConnect™
configuration software
Installation
Emerson FB3000 RTU Instruction Manual
Use
Chassis ground lug, panel installation, removal of rear panel.
Personality module removal
Battery removal
Battery removal
Software configuration
D301851X012
October 2022
7