Upgrade kit instructions
P/N 3-9000-784
2
Before you begin
This section shows all of the parts and tools required to perform the upgrade. Ensure that
all of these items are available before taking the Mark III meter out of service.
2.1
Required parts
Ensure that you have received the 3410 Series retrofit components to upgraderetrofit your
meter.
2.2
Tools required
Figure 2-1: Required tools
A. 1/8" flat-blade screw driver
B. ¼" flat-blade screw driver
C. 3/8" drive ratchet wrench
D. 3/8" drive - extension - at least 3.5" long
E. 3/8" drive - 7/16" socket
F. Allen wrench - size 6mm Daniel P/N 2-4-9200-501(included in Retrofit kit)
G. Crescent wrench for cable glands and electrical conduit
Daniel MeterLink
information and collect the configuration in the meter and then convert and download the
configuration into the new 3410 Series electronics. Always use the latest version of
Daniel MeterLink
http://www.emerson.com/en-us/catalog/automation-solutions/measurement-
instrumentation/flow/daniel-meterlink
3410 Series Electronics Upgrade kit instructions
™
is required to communicate with the meter electronics, access
™
. Upgrades to the latest version are available at:
Before you begin
July 2019
15