Environmental Specifications; Required Tools - Emerson FB1100 Instruction Manual

Emerson FB1100 Flow Computer Instruction Manual
D301752X012
August 2020
2.2

Environmental Specifications

This section summarizes the environmental specifications for the device. For full details, refer to
the product data sheet
Table 2-1: Environmental Specifications
Specification
Ambient Temperature
Maximum Process Connection
Temperature
Humidity
Vibration
2.3

Required Tools

Certain tools and equipment are required for installing and servicing the flow computer.
Table 2-2: Required Tools
Tool
Torque wrench
2.5 mm hexagonal wrench
3 mm hexagonal wrench
9/16 in hexagonal wrench
1 1/16 in combination wrench
#1 Phillips-head screwdriver
#2 Phillips-head screwdriver
1/8 inch flat-head screwdriver
Laptop PC running Field Tools with FBxConnect
configuration software
12
FB1100 Flow Computer (D301781X012).
Range
-40°C to +80 °C (-40 °F to +176 °F) - no battery, C1D1/C1D2
-40°C to +80 °C (-40°F to +176 °F) - lead acid battery, C1D1/C1D2
-40°C to +80 °C (-40 °F to +176 °F) - lithium battery, C1D1/C1D2
-40°C to +80 °C (-40 °F to +176 °F) - no battery, ATEX/IEC Ex db
-40°C to +80 °C (-40 °F to +176 °F) - no battery, ATEX/IEC Ex nA
120 °C (248 °F)
5% to 95% non-condensing
2g over 10 to 150 Hz; 1g over 150 to 200 Hz
Use
For bolting/mounting the flow computer
For manipulating rotation set screw
For screw for M4 x 0.7 end cap retaining clamp
(ATEX required)
For installing/removing ¾ in NPT conduit plugs
For installing/removing ¾ in NPT to M20 thread
reducer (ATEX required)
For screws on HMI module
For screws on other modules and boards
For 5.08 mm pitch terminal block connections
For software configuration
Installation