Electronic Programme Guide (Epg); Troubleshooting - Strong SRT 2402 User Manual

Country Settings:
Antenna Power:
LCN:
Auto Scan:
Manual Scan:
Scan Type:
7.5.3 DVB-C Installation
For cable installation select DVB-C in the DTV tuner section. If you don't make that selection the DVB-T
menu options will be displayed. The process of auto search and manual search works in the same way as
described in the DVB-T chapter above.

7.6 Electronic Programme Guide (EPG)

The Electronic Programme Guide (EPG) shows programme schedules and information for current
programmes and coming programmes up to the 7 next days. Press EPG button on remote to open the
EPG in viewing mode. To change to other channel, press the RED and GREEN buttons. Press t upq to
navigate in the EPG menu. Press OK to get detailed information about the programme. Press the BLUE
Timer button to set a reminder for a programme or to programme a recording.

8.0 TROUBLESHOOTING

There may be many reasons that affect the correct operation of your Android receiver. If the receiver
does not work as you expect, please follow the steps outlined below. If after performing these operations
the receiver still does not work well, contact your dealer or service centre in your area or write an email to
our support via our website www.strong.tv.
If the DTV part shows problems with reception, first check if all cables and connectors still are in good
condition. Check whether your dish/antenna still is fixed well and pointed optimally to the satellite of
your choice. Check whether the satellite settings in the menus are still correct. If all is OK, you can reset
the unit back to the factory settings and try to install again. Refer to chapter 7.3.7 of this user manual.
If you experience problems in the Android part, first check whether it is caused by an application. Try
to clear the data or remove the app and check if this solves the problem. Please enter Settings – Apps --
(select the app) -- Clear data and then return to the menu and test if all works again.
If not successful you can reset the receiver back to the factory settings and try to install it again. Refer to
chapter 6.5 of this user manual.
WARNING:
Select your region.
Set to On if you use an active antenna. When set to On, 5 V will be present at
the ANT IN connector of the receiver. Select Off for passive antennas.
Set LCN (Logical Channel Numbering) to On to activate operator defined
channel numbering or Off to store channels in found order. Sorting of
channels in the channel list with LCN is not possible.
Select to start searching all frequencies for available channels. All stored
channel from before will be deleted.
Select to start searching on one frequency for available channels. All stored
channel from before will be kept in the channel list. When all settings have
been made, press OK to start scanning.
Select FTA to search and store channels which can be watched freely. Select
All to include encrypted channels in the channel list. However this device
does not decode any channels.
Do not open the receiver cover. This action will damage the warranty seals
and warranty repairs will be denied.
21