Strong SRT 2402 User Manual page 24

7.5.1 Satellite Installation
In this menu below you will find level and quality bars to optimize the signals for your dish.
Use p/q to select one or more satellites. Press OK to mark or unmark them. As soon as you have made
your selection, press u to jump to the right side of the screen where you can select a satellite and add
the corresponding settings as DiSEqC ports.
By the end of the setup you can start the scan process by pressing the BLUE and Scan button.
SAT
TP
LNB type
LNB voltage
SatCR
LNB Power
22KHz
ToneBurst
DiSEqC 1.0
DiSEqC 1.1
Motor
NOTE:
There is also the possibility to change (add, edit or delete) a satellite or transponder by pressing INFO
and search for channels: Auto search, Manual search, Blind scan and Network search. Press the BLUE
button to display the Scan menu and press OK to confirm.
7.5.2 DVB-T/T2 Installation
In this menu you can select Country, Antenna power, LCN modes and search for channels.
Below in the screen you will find level and quality bars for optimizing the best signals of your terrestrial
antenna.
20
Select a satellite with t u. If you only mark one satellite you cannot select
another.
Select a transponder if you want to scan or adjust the dish on a selected
frequency. Press OK to call the overview list.
Default is set to 9750/10600 which is the most common setting for LNBs
(Universal type). Select another if you are using a different type LNB which
needs other values.
Select On to increase the LNB voltage if you use a long coaxial cable to
compensate for decrease of the LNB supply voltage.
Select one of the frequencies if you are connected to a SatCR system. SatCR is
a special system which mainly is used in apartment buildings to provide one
satellite dish system to many users at once. To use this function, contact your
property management or system installer. If SatCR is activated, other settings
below are not used. For normal use, default is set to Off.
Default is set to 13/18V. The others functions are intended for specialized staff
only.
Select Off or On if you use a special dish setup. For normal use this is default
set to Auto.
If you are using a legacy type switch to switch between 2 satellites, setup your
port to the satellite you selected above.
If you are using a DiSEqC 1.0 switch to switch between 2, 3 or 4 satellites,
setup your port to the satellite you have selected above.
If you are using a DiSEqC 1.1 to switch between 5 to 16 satellites, setup your
port to the satellite you've selected above.
If you are using a motor drive to move between satellites, setup the motor
drive by using DiSEqC 1.2 or DiSEqC 1.3 protocols.
We strongly advise to ask your local installer to help install motor and
settings.