Strong SRT 2402 User Manual page 14

Select Next and confirm with OK to go to Step 2.
Step 2: Channel scan
Start Scan:
Load channel list from USB:
Step 3: Channel Installation
DVB-T/T2 or DVB-C Installation
Satellite Installation:
DVB-T/T2 or DVB-C Installation
Country (Region):
Antenna Power:
LCN:
Scan Type:
NOTE:
By the time all settings are finished, select Auto scan for full search of all channels or select Manual Scan
for only one frequency.
Press OK to start scanning.
The receiver will search for all available channels now.
When the scanning is finished, the receiver switches to viewing mode.
10
Press OK to enter this menu which shows the options for channel
scanning. Selection of DVB-T/T2 Installation allows you to search
terrestrial channels by using an indoor or outdoor antenna. If you
selected DVB-S/DVB-C during the previous step parameter Tuner
Type, you will get the DVB-C Installation option which allows you
to search cable broadcasted channels. Select Satellite Installation
to search satellite channels of your choice by using a satellite dish
antenna.
Select this option and press OK or u if you want to load a channel
list which has been made before and was saved as backup on a USB
stick.
The receiver shows the DVB-T/T2 or DVB-C Installation screen.
The receiver shows the DVB-S Installation screen. The default setting
is ASTRA 19.2 on DiSEqC port 1. Use pq if you would like to select a
different satellite signal and press OK to select or deselect. To modify
the settings, press u to enter. When all settings are finished, press
BLUE and select Scan to enter the scanning process menu. Select
options Scan, Scan type, Service type and Sat Type here. By selecting
Sat Type as Multi, you may scan multiple satellites, by selecting Single
you scan only one satellite signal. Press OK to start.
To select the country where you are using the device to set up the
steps in the scanning process automatically.
(Only for DVB-T/T2.) Switch to On if you use an active antenna. By
setting to On, 5 V will be present at the ANT IN connector of the
receiver. Select Off for passive antennas.
Switch to On if your operator uses automatic channel sorting also
called as LCN. This option does not allow any manual channel sorting
afterwards. Select Off if you would like to sort the channels yourself
after the scanning process.
Select All to store scrambled and Free-To-Air channels or select FTA to
store only Free-To-Air channels.
Scrambled channels cannot be viewed with this receiver.