Test Run - Grizzly T28366 Owner's Manual

6. Thread miter lock lever into miter base
(see Figure 17).
Miter
Lock
Lever
Figure 17. Miter lock lever installed.
7.
Add coolant to coolant reservoir (refer
to Checking Coolant on Page 30 for
instructions).
8. Install blade (refer to Installing/Changing
Blades on Page 24 for instructions).
T28368 —Blade for T28366 Cold Cut Saw
This 160-tooth, 10" (250mm) blade, provides,
straight, burr-free cut and precise miters for a
wide range of metal projects. Features a 1.26"
(32mm) bore.
Figure 18. T28368 blade for T28366 Cold Cut
Saw.
Model T28366 (Mfd. Since 04/18)
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
Miter
If you find an unusual problem during the test run,
Base
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, and 2)
the safety disabling mechanism works correctly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.

Test Run

-17-