Table of Contents
Advertisement
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye or face injury from
flying chips, always wear approved safety
glasses and a face shield when operating
this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model T28366 (Mfd. Since 04/18)
manual
BEFORE
To complete a typical operation, the operator
does the following:
1.
DISCONNECTS MACHINE FROM POWER!
2.
Checks
coolant reservoir.
3.
Examines workpiece to make sure it is suit-
able for cutting.
4.
Adjusts miter angle, if necessary, to desired
angle of cut.
5.
Ensures proper blade clearance of vise and
table.
6.
Adjusts workpiece, then secures it in vise.
7.
Connects saw to power.
8.
Turns master power switch to "1", then resets
Emergency Stop button.
9.
Puts on safety glasses and face shield.
10. Presses start button on lever arm to start
blade and flow of coolant.
11. Lowers blade into workpiece while confirming
coolant is flowing onto workpiece.
12. Raises blade and releases trigger button to
stop machine.
-19-
Advertisement
Table of Contents
