Adjusting Miter Lock Lever - Grizzly T28366 Owner's Manual

Adjusting Miter
Lock Lever
The miter lock lever (see Figure 49) ensures the
swiveling saw base remains locked at a desired
angle during the cut.
Lock lever adjustment components can be
accessed underneath the saw base.
Item(s) Needed
Hex Wrench 6mm .............................................. 1
Wrench Open-Ends 14mm ................................ 1
Miter Lock
Lever
Figure 49. Location of miter lock lever.
-36-
To adjust lock lever:
1. DISCONNECT MACHINE FROM POWER!
2. Loosen cap screws securing miter lock lever
to lock bolt shown in Figure 50.
Qty
Miter
Lock
Lever
Figure 50. Miter lock lever adjustment
3.
Rotate miter lock lever left or right, as need-
ed. Re-tighten cap screws and tensioner hex
nuts, and then test miter lock lever range of
movement.
Note: Check lock lever clearance to ensure
it does not interfere with the vise handwheel
rotation when fully locked.
Tensioner
Lock
Hex Nut
Bolt
(1 of 3)
Cap
Screw
(1 of 3)
components.
Model T28366 (Mfd. Since 04/18)