Test Run - Grizzly G0561 Owner's Manual

25. With help of an assistant, remove bandsaw
from blocks.
26. Adjust feet to level bandsaw as needed, then
tighten hex nuts against machine base to
secure.
27. Insert work stop rod through hole in base and
lock in place with hex bolt (see Figure 26).
28. Slide work stop over rod, then tighten thumb
screw to secure (see Figure 26).
Work Stop
Figure 26. Work stop installed.

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following: 1)
The motors power up and run correctly, and 2) the
automatic shut-off tab shuts down power.
Model G0561 (Mfd. Since 01/18)
To test run machine:
Stop Rod
1.
2.
Thumb
Screw
3.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Clear all setup tools away from machine.
Fill cutting fluid reservoir as described in
Cutting Fluid System section on Page 38.
NEVER turn ON coolant pump without
cutting fluid in the reservoir or when cutting
fluid is low or you will overheat pump and
void warranty!
Open coolant control valve (see Figure 27).
Figure 27. Location of coolant control valve.
Control
Valve
-21-