Grizzly T28366 Owner's Manual page 20

To test run machine:
1. Clear all setup tools away from machine.
2. Press Emergency
Figure 19).
Start
Button
Figure 19. Location of machine power controls.
3. Connect machine to power supply.
4. Rotate Emergency
Figure 20) clockwise to reset.
Figure 20. Resetting emergency stop button.
5.
Turn master power switch to "1" (ON)
position (see Figure 19).
6.
Press start button on lever arm. Blade should
begin spinning.
-18-
Stop button (see
Emergency
Stop
Master
Power
Switch
Stop button (see
7. Slowly turn coolant flow control valve to open
position (see Figure 21). Coolant should
begin flowing onto blade.
Note: Starting machine with coolant flow
control valve fully open will make a mess
and can make the work area unsafe due to a
slipping hazard on floor.
Figure 21. Location of coolant flow control valve.
8.
Motor should run smoothly and without
unusual problems or noises.
— Address strange or unusual noises by
referring to Troubleshooting on Page 34
for help.
— Always disconnect machine from power
BEFORE investigating or correcting poten-
tial problems.
9. Turn machine OFF by releasing start button.
10. Press Emergency Stop button, then press
start button. Saw should NOT start.
If saw does start, turn off master power
switch and immediately disconnect power to
saw. The Emergency Stop button may not
be working properly. The safety feature must
work properly before proceeding with regular
operations. Refer to Troubleshooting on
Page 34 for help.
Model T28366 (Mfd. Since 04/18)
Coolant Flow
Control Valve