Grizzly T28366 Owner's Manual page 33

Coolant
Coolant Type ... H9240 Soluble Oil or Equivalent
Coolant Amount ........................................
Check/Add Frequency ................................. Daily
Change Frequency ..................................Monthly
Item(s) Needed
Goggles ............................................................. 1
Gloves ............................................................... 1
Respirator (Optional) ......................................... 1
Empty 2-litre Container ...................................... 1
New Coolant ............................................ 2 Liters
Siphon Hose (2 ft. or Longer) ............................ 1
Small Brush ....................................................... 1
Disposable Shop Rags ...................... As Needed
To add coolant:
1.
DISCONNECT MACHINE FROM POWER!
2.
Pre-mix coolant in an empty 2-liter container.
Note: Refer to manufacturer's specifications
for proper water/oil mix.
3. Wearing protective equipment, open coolant
reservoir lid (see Figure 43).
Coolant
Coolant
Pump
Reservoir
Lid
Figure 43. Location of coolant system
components.
4.
Pour coolant into reservoir until pump is
submerged (approximately
5.
Close coolant reservoir lid.
Model T28366 (Mfd. Since 04/18)
⁄ Liter
1
2
Qty
Hose
Tray
Screen
Reservoir
Screen
Coolant
Reservoir
⁄ full).
3
4
BIOLOGICAL AND POISON
HAZARD! Use proper per-
sonal protection equipment
when handling coolant and
follow federal, state, and
fluid manufacturer require-
ments to properly dispose
of coolant.
To drain and clean coolant reservoir:
1.
DISCONNECT MACHINE FROM POWER!
2.
Wearing protective equipment, open coolant
reservoir lid (see Figure 43).
3. Remove and wipe coolant pump clean
(see Figure 43).
4. Siphon and dispose of old coolant and swarf
according to federal, state, and fluid manu-
facturer's requirements.
5. Thoroughly clean tray screen, reservoir
screen, and inside of coolant reservoir
(see Figure 44).
Figure 44. Cleaning screens and reservoir.
6. Use a rag to wipe out residual coolant and
swarf inside reservoir.
7.
Place pump back into coolant reservoir.
8. Add coolant (refer To add coolant procedure
on This Page for instructions).
Tray
Screen
Reservoir
Screen
-31-