Adjusting Miter Angle - Grizzly T28366 Owner's Manual

Adjusting Miter
Angle
The head and column rotate 90° left or right of
center for precise angled cuts. The miter scale
shows the angle of the blade, and the miter lock
lever secures the angle for repeated cuts.
Ensure saw is properly mounted to benchtop
(see Page 15) before performing cuts, as saw
base can shift with larger workpieces.
Prior to cutting, always check vise jaws for
blade clearance. Failure to do this could
cause blade to contact vise during cut,
resulting in damage to blade or jaws.
-28-
To set miter angle:
1. DISCONNECT MACHINE FROM POWER!
2. Release miter lock lever (see Figure 38).
Miter Scale
Miter Lock
Lever
Figure 38. Location of miter lock lever and miter
scale.
3.
Rotate saw headstock to desired angle using
miter scale as a guide. Once desired angle is
reached, move miter lock lever left to secure
setting.
4.
Ensure blade clearance by lowering saw
blade. If necessary, adjust vise jaw to provide
adequate clearance, as outlined in Adjusting
Vise on Page 27.
5. Return saw to upright position.
Model T28366 (Mfd. Since 04/18)