Installing/Changing Blades - Grizzly T28366 Owner's Manual

Installing/Changing
Blades
Metal cutting blades should be checked
regularly for wear or damage to help ensure
operator safety and high-quality cutting results.
Always immediately replace any blade found with
damage.
Item(s) Needed
New 10" Cold Cut Saw Blade ............................ 1
Hex Wrench 5mm .............................................. 1
Hex Wrench 8mm .............................................. 1
Retaining Ring Pliers ......................................... 1
The teeth of saw blades are
sharp and can easily cut
fingers and hands. Always
wear heavy leather gloves
when handling saw blades.
To install/change blade:
1.
DISCONNECT MACHINE FROM POWER!
2.
Disconnect blade
removing cap screws connecting linkage to
base of column neck (see Figure 30). This
releases tension on retractable blade guards
(see Figure 31).
Figure 30. Location of blade guard linkage and
cap screws.
-24-
Qty
guard linkage by
Blade Guard
Linkage
Cap
Screws
3. Remove arbor cap screw (see Figure 31).
It has left-hand threads and loosens when
turned clockwise.
Retractable
Blade
Guard
Figure 31. Removing arbor cap screw.
4. Remove retaining ring from retractable guard
hub (see Figure 32) to provide clearance to
remove/install blade. DO NOT remove plastic
bushing from hub.
Retaining
Ring
Figure 32. Removing retaining ring.
Model T28366 (Mfd. Since 04/18)
Cap
Screw
Retractable
Loosen
Blade
Guard
Plastic
Bushing