Grizzly T28366 Owner's Manual page 35

Push the oil can nozzle tip against ball oiler,
and pump oil can twice. If you see sludge and
contaminants coming out of the lubrication area,
continue pumping oil can until the oil runs clear,
and wipe away any excess oil. There are two ball
oilers, located on the front and rear vise bodies
(see Figure 46).
Note: For best performance, periodically clean
leadscrew thoroughly with mineral spirits or other
degreaser and then relubricate.
Vise Leadscrew
Figure 46. Vise leadscrew lubrication.
Column Hinge Pin
Lube Type ...Model T26685 or ISO 32 Equivalent
Lube Amount ........................................Thin Coat
Lubrication Frequency ........... 8 hrs. of Operation
Proper lubrication of the column hinge-pin allows
for smooth movement of the saw headstock.
If saw headstock movement becomes difficult,
apply a small amount of oil to column joints (see
Figure 47). Move the saw headstock back-and-
forth several times to distribute oil evenly.
Oil Access
(1 of 2)
Figure 47. Location of column hinge pin.
Model T28366 (Mfd. Since 04/18)
Ball Oiler
Saw Base Pivot
Lube Type ...Model T26685 or ISO 32 Equivalent
Lube Amount ........................................Thin Coat
Lubrication Frequency ........... 8 hrs. of Operation
Proper lubrication around the saw base pivot
allows for smooth rotation when adjusting the
miter angle.
If base pivot movement becomes difficult, apply
a small amount of oil to openings beside the
miter angle gauge (see Figure 48). Rotate the
base back-and-forth several times to distribute oil
evenly.
Miter
Angle
Gauge
Figure 48. Base pivot oil locations.
Oil Access
(1 of 2)
-33-