Test Run - Grizzly G0555LX Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, and 2)
the switch disabling padlock disables the switch
properly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
-24-
To test run machine:
1. Clear all setup tools away from machine.
2. Connect machine to power supply.
3. Turn machine ON, verify motor operation,
and then turn machine OFF.
The motor should run smoothly and without
unusual problems or noises.
4.
Insert disabling padlock through switch
button.
Shaft
Figure 27. Switch disabling padlock inserted into
ON button.
5.
Try to start machine by pressing switch
button.
Machine should NOT start. If it does start,
the switch disabling feature is not functioning
properly and the switch must be replaced.
Model G0555LX (Mfd. Since 1/14)
Padlock