Table of Contents
Advertisement
OPM 3000
Figure A-6. Main, Setup,
About Page
Figure A-7. Opacity/mg
Display Page
A-6
6. When finished press the ESC button until you display the Main, Setup,
About page (Figure A-6).
7. Press the enter key ↵ while the cursor arrow is pointing to Main to
access the opacity/mg display page (Figure A-7).
8. The O.D. display and the Ch. 2 output will be O.D. From the main
display you can toggle the O.D. display by pressing the right arrow
button
The latest O.D. measurement will appear.
9. Record the source particulate emissions in O.D. during experimental
testing using the OD Display or the Ch. 2 output signal.
Instruction Manual
IM-105-3000, Rev 2.0
November 2008
Advertisement
Table of Contents
