Instruction Manual
IM-105-3000, Rev 2.0
November 2008
Section 8
SPARE PARTS
OPM 3000
Recommended Spare
Parts
http://www.raihome.com
Spare Parts
Spare Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 8-1
Contact an Emerson Process Management sales department with the serial
number of your instrument and they will make recommendations based on
your system. Below are typical spares that should be considered.
Figure, Item
Part No.
5-1, 1-1
6A00187G11
6-1
1A99993H01
2-6
1A99993H02
6-3
1A99993H03
6-3
1A99993H04
1-1
1A99993H07
N/A
1A99993H08
N/A
1A99993H09
N/A
1A99993H10
2-8, 1-1
1A99993H28
Description
Zero jig on-line test reflector kit. OPM 3000 Opacity/Dust
Density Monitors, one 84% neutral density filter and case.
Main lamp pre-focused assembly, see "Lamp Replacement"
in Section 6: Maintenance.
Transceiver/retro reflector latch, spring and gasket repair kit.
R/M signal processor board, see "Circuit Board
Replacement" in Section 6: Maintenance.
Power/modulator board, see "Circuit Board Replacement" in
Section 6: Maintenance.
Standard air purge blower, min 5 CFM @ 36 inches H
Max 36 CFM @ 2 Inches H
O.
2
Air flow switch assembly for air purge blower.
4-pack air filter replacement element (ID 1.5 OD 4.5 HT
5.875).
Transceiver to control unit cable, 6 feet.
OPM 3000 control unit.
OPM 3000
O,
2