Automated Performance Tests; Loading The Language Disks And Software - Agilent Technologies 8510C Service Quick Reference Manual

Automated Performance Tests

This test requires the following disks:
• BASIC 5.0 or greater
• Language extension disks (Clock, MAT, Graph, and I/O)
• Drivers disk (GPIB)
• Performance Verifications Software, Revision A.05.01 (part number 08510-10033)

Loading the Language Disks and Software

1. Load BASIC 5.0 or higher into the disk drive for autostart on your controller. Press
cycle the power of the controller to activate autostart.
SHIFT, PAUSE or
NOTE You must have 4 Mb of memory for the program to run. Check by typing
SYSTEM $ (AVAILABLE MEMORY). Press
2. After BASIC is loaded, the disk drive LED goes off, and a BASIC READY prompt appears
on the controller display. Remove the disk.
3. Insert the language extensions disk in the right-hand drive and load the following files
one at a time using the 9836A keyboard. Type:
LOAD BIN "ERR", then press
extension and drivers.
LOAD BIN "CLOCK", then press
LOAD BIN "GRAPH", then press
LOAD BIN "MAT", then press
LOAD BIN "I/O", then press
4. Remove the language extensions and insert the drivers disk into the right-hand drive.
Type LOAD BIN "HPIB".
Press
EXECUTE
Remove the drivers disk.
Type MSI":,700,0".
Press
EXECUTE
8510C Service Quick Reference Guide
EXECUTE
EXECUTE
EXECUTE
EXECUTE
EXECUTE
.
to specify mass storage device on the external disk drive.
.
RETURN
. Repeat to load the remaining language
.
.
.
.
Performance Verification
Automated Performance Tests
4-7