Saving A File; Step 1. Set Up The Analyzer Trace - Agilent Technologies ESA Series Getting Started Manual

Saving a File

You can save files (setups, states, traces, limits, corrections, measurement results, or screens) to a floppy
disk (A:\), or the internal drive (C:\). In this example you will save a trace to the internal C: drive.
NOTE
Trace files are not bitmap files. Files saved as
applications or converted. If you require the use of other applications, for example
Microsoft Word or Microsoft Excel, be sure to save your files as .gif or .wmf formats
using
Screen

Step 1. Set up the analyzer trace

1. Perform a factory preset by pressing
2. Turn on the internal 50 MHz alignment signal of the analyzer as follows:
• For the Agilent E4401B and E4411B, use the internal 50 MHz alignment signal of the analyzer as
the signal being measured. Press
• For all other models connect a cable between the front-panel AMPTD REF OUT to the analyzer
INPUT, then press
3. Set the center frequency to 50 MHz by pressing press
4. Set the span to 75 MHz by pressing
display.
Chapter 4
for your file .
Type
,
Preset Factory Preset
Input/Output
,
Input/Output Amptd Ref Out
SPAN , Span
Viewing Catalogs and Saving Files
Trace cannot be imported into other
(if present).
, (On).
Amptd Ref
(On).
,
FREQUENCY Center Freq
, 75 , MHz . The reference signal will appear on the
Saving a File
, , .
50 MHz
55