Beta RR 400 Operating Instructions Manual page 121

3
CHECKING THE OIL LEVEL IN THE HY-
1
DRAULIC CLUTCH
To check the oil level in the clutch pump,
first remove cover 2.
Remove the two screws 1 and take off
cover 2 together with the rubber bellows.
With the clutch pump in a horizontal posi-
tion, the level of the oil should be 4 mm
below the upper rim.
2
If necessary top up with ARAL VITAM LS
hydraulic oil, which is available from your
BETAMOTOR dealer.
BLEEDING THE HYDRAULIC CLUTCH
To bleed the hydraulic clutch, first remove
the clutch pump cover. To do this, remove
3
the two screws 1 and take off cover 2
together with the rubber bellows. Remove
the breather valve from clutch pump cylin-
der 3. Fit the bleed syringe filled with SAE
10 hydraulic oil in the breather valve
socket. Pump in oil until it comes out of
clutch pump hole 4 with no air bubbles.
Ensure that no oil overflows. The bleed
syringe is available from BETAMOTOR
dealers. Once the bleeding is complete,
4
check the oil level in the clutch control cyl-
inder.
If necessary top up with ARAL VITAM LS
hydraulic oil, which is also available from
your BETAMOTOR dealer.
GB
43