Extended Parallel Port Header (Jp8); Ir Header (Jp7) - Shuttle FB75 User Manual

Extended Parallel Port Header (JP8)

E6
One parallel port header is located at the rear panel of the mainboard. The
header is used to connect the cable attached to a parallel connector. But the
parallel cable and connector are optional at the time of purchase.

IR Header (JP7)

E7
If you have an Infrared device, this mainboard can implement IR transfer
function. This mainboard supports Normal, IrDA, ASKIR, or SCR transfer
mode. To enable this function, attach a 6-pin infrared device cable to the IR
(JP7) header. Please note that every pin is properly allocated. If not, your IR
device may be damaged.
JP7
6 5
4 3
2 1
1
Pin Assignments:
1=N/C
3=VCC
5=IRTX
2=KEY
4=GND
6=IRRX
- 38 -
JP8
1
JP7
1