Shuttle FB75 User Manual page 52

Base Memory/Extended Memory/Total Memory
These items are automatically detected by the system at start up time.
These are display-only fields. You can't make change to these fields.
******************************************************
IDE Adapters
The IDE adapters control the hard disk drive. Use a separate sub-menu
to configure each hard disk drive.
IDE HDD Auto-Detection
Press <Enter> to auto-detect HDD on this channel. If detection is
successful, it fills the remaining fields on this menu.
IDE Channel 0/Channel 1 Master/Slave
The item defines the type of fixed disk.
Ø The choice: None, Auto, or Manual.
Access Mode
Choose the access mode for this hard disk.
Ø The choice: CHS, LBA, Large, or Auto.
Capacity
Note that the disk drive capacity (approx.) is usually slightly greater than
the size of a formatted disk given by a disk checking program.
The following options are selectable only if the 'IDE Channel 0/
Channel 1 Master/Slave' item is set to 'Manual', and the 'Access
Mode' item is set to 'CHS'.
Cylinder
Set the number of cylinders for this hard disk.
Ø Min = 0, Max = 65535
Head
Set the number of read/write heads.
Ø Min = 0, Max = 255
Precomp
Warning: Setting a value of 65535 means no hard disk.
Ø Min = 0, Max = 65535
Landing Zone
Set the Landing Zone size.
Ø Min = 0, Max = 65535
Sector
Number of sector per track.
Ø Min = 0, Max = 255
******************************************************
- 48 -