Hardware Setup Instructions - Noraxon Ultium EMG System User Manual

Ultium EMG Hardware User Manual

5.4 Hardware Setup Instructions

Step 1
Insert the USB-B (smaller) end of the USB cable
(CBL2) into the USB connector on the rear of the
Ultium Receiver (880).
Insert the opposite end of the USB cable into an
available USB port on the computer.
Step 2
Insert one EMG Smart Lead (842) into each EMG
probe (810).
Step 3
Insert the EMG probes into the Sensor Docking
Station (883).
Step 4
Insert the power supply (PSU1) barrel connector
into the jack of the Ultium Receiver.
Step 5
Connect the Receiver to the Sensor Docking
Station (883). This will charge the sensors
(Rev J)
15