Installing The Hardware - Noraxon Ultium EMG System Quick Start Manual

Ultium EMG Quick Start Guide

2 Installing the Hardware

Step 1
Insert the USB-B (smaller) end of the USB cable
(CBL2) into the USB connector on the rear of the
Ultium Receiver (880).
Insert the opposite end of the USB cable into an
available USB port on the computer.
Step 2
Insert one EMG Smart Lead (842) into each EMG
probe (810).
Step 3
Insert the EMG probes into the Sensor Docking
Station (883).
Step 4
(Rev A)
4