Configuration Using Ultium Smart Leads - Noraxon Ultium EMG System User Manual

Ultium EMG Hardware User Manual

5.7 Configuration using Ultium Smart Leads

Make sure the Smart Lead is connected to the
Ultium sensor before choosing Detect Sensors
in Charger. The Ultium sensor LED will flash
purple 3 times after a Smart Lead is connected
and then will resume blinking blue. When a
Smart Lead is disconnected the LED will flash
orange 3 times then resumes blinking blue.
If the software does not recognize the Smart
Lead, the sensors may require a firmware
update. Follow the instructions for Device
Software (firmware) updates.
The Smart Lead will appear using the serial
number of the Smart Lead, and not the Ultium
sensor.
Click on OK (in the bottom of the dialog box)
when done.
(Rev J)
19