Additional Ultium Emg Settings And Features; Ultium Receiver Synchronization - Noraxon Ultium EMG System User Manual

Ultium EMG Hardware User Manual

7 Additional Ultium EMG Settings and Features

7.1 Ultium Receiver Synchronization

The Ultium System may be used with other devices. In order to synchronize the signal of the Ultium
System with these other devices, it is necessary to set up both the software and hardware correctly.
The Receiver can accept a sync pulse via the Sync In port located on the back of the Receiver unit.
7.1.1 Sync In
The Sync In port allows a capture of a TTL (0-5V) sync signal. The key purpose is to allow Ultium data
to be synchronized with data from other devices.
7.1.2 MR3 Sync Setup
Ultium Receiver Sync is set up in the MR3 software, in Hardware Setup, which is found under the
General tab. To enable Sync, simply check the Use Noraxon MyoSync checkbox.
25
(Rev J)