Noraxon Ultium EMG System User Manual page 31

Ultium EMG Hardware User Manual
Step 2
Insert power supply (PSU1) barrel connector into
the jack of the Ultium Receiver. Insert the EMG
Sensor Charger Power Source into a power strip
(recommended) or into the wall outlet (mains).
Step 3
Connect the Receiver to the Sensor Docking
Station (883). This will charge the sensors.
Verify that the "charge" indicator on all

sensors glows amber (yellow).
Charge for approximately 3 hours or until

each sensor "charge" indicator turns off.
8.2.2 Cleaning The EMG Sensors
Safety precautions for cleaning the EMG Sensors: Safety precautions for cleaning the EMG Sensors: Safety precautions for cleaning the EMG Sensors: Safety precautions for cleaning the EMG Sensors:
Clean the bottom of the EMG Sensors on a regular basis. The EMG Sensors can be cleaned with a cloth
slightly dampened with a solution of mild soap and water or isopropyl alcohol.
The EMG Sensors are not constructed to withstand repeated application of any disinfectant solution.
Likewise, the EMG Sensors are not warranted against exposure to any of the conventional forms of
sterilization.

to clean the bottom of the EMG Sensors
CAUTION

8.2.3 Storing the EMG Sensors
It is recommended to store the sensors inside the sensor docking station. While in use, we recommend
plugging this station into power to maintain charge during storage. During periods of time in which you
do not plan on using the sensors, you can leave the sensor docking station unplugged from power for a
maximum of 3 months.
Note: It is necessary to charge the sensors once every 3 months.
The batteries will undergo expansion if left alone for too long. Every 3 months fully charge the sensors
once and then normal storage without connection to power may resume.
(Rev J)
Only use a damp cloth with mild soap and water or isopropyl alcohol
D D D D O NOT O NOT immerse EMG Sensors in any water or liquid. O NOT O NOT
31