Noraxon Ultium EMG System User Manual page 18

Ultium EMG Hardware User Manual
Note: Firmware updates for the Receiver will be
indicated here, if they are required.
Step 4
Click the Sensors Tab.
Place all Ultium Sensors into the chargers and
attach the chargers to the Ultium Receiver. If
you have any non-EMG Smart Leads, attach
them to any EMG sensors.
Click Detect Sensors in Charger to load all serial
numbers into the MR3 software.
Step 6
After detection is complete, click Yes to replace
all existing sensor serial numbers associated
with this device.
Step 7
Click on OK (in the bottom of the dialog box)
when done.
Note: Sensor serial numbers appear in the order
that they are placed in the charging doc, starting
at the end with the LEDs (opposite of the
charging port).
(Rev J)
18