Setting Parallel Interface Parameters - QMS 1725E Reference

Choices
Default
Notes

Setting Parallel Interface Parameters

Use the Administration/Communications/Parallel menu to set the par-
allel interface values used for printer-host communications.
Mode
The parallel interface supports Centronics parallel communication as
well as IEEE 1284 bidirectional parallel communication.
Menu
Choices
Default
Printer Configuration
Normal—Enable standard, ASCII hex protocol. Data is sent
and received in ASCII format. This mode is recommended if
you do not print binary data. It was designed for data in the
printable ASCII range. Print jobs can alter the PS protocol
value through PostScript operators.
Normal Fixed—Enable standard, ASCII hex protocol. Print
jobs cannot alter this value through PostScript operators.
Binary—Enable binary communications protocol. Print jobs
can alter this value through PostScript operators. Data in the
printable ASCII range also prints.
Binary Fixed—Enable binary communications protocol. Print
jobs cannot alter this value through PostScript operators. Data
in the printable ASCII range also prints.
Normal
See chapter 5, "Additional Technical Information," for a full
discussion of PS Protocol.
Administration/Communications/Parallel/Mode
Interactive—Establish two-way communication between the
host and the printer.
Noninteractive—Establish one-way communication from the
host to the printer.
Disabled—Turn off parallel communication with the host. The
printer stops accepting print jobs over the parallel interface.
Noninteractive
Communications
4-23