Software Setting Mode - Epson TM-H6000IV-DT Technical Reference Manual

Software Setting Mode

In the software setting mode, configure the printer memory switches. See
items.
• Receipt print density
• Transmission speed for serial interface
• Automatic paper reduction
• Autocutting at roll paper cover close
• Roll paper width
• Interface selection
• Power supply unit capacity
• Receipt print speed
• Error control
• Power on notice
• NV capacity (User NV memory, NV graphics memory)
• Command execution during offline
.
Follow the steps below
1
After implementing the self-test, press the Feed button for an extended period (1
second or more) to select the mode.
The mode selection guidance is printed, and the paper LED flashes.
2
After pressing the Feed button for three times(less than 1 second), press it for an
extended period (1 second or more) to print the NV graphics information.
The Software setting mode guidance is printed.
3
After pressing the Feed button for a short time (less than 1 second) for the number of
times indicated in the printing results, press it for an extended period (1 second or
more) to select the setting item.
4
After pressing the Feed button for a short time (less than 1 second) for the number of
times indicated in the printing results, press it for an extended period (1 second or
more) to select the setting value.
The customized value will be saved, and the items that can be set in the software setting mode will
be printed again.
5
In order to finish, either turn power off or select "Exit and Reboot Printer."
Chapter 2 Printer Functions and Settings
"Functions" on page 55 for the setting
2
63