Software Setting Mode
Set the printer's memory switches and customized values.
Print density
Auto reduction of amount of paper to use
Enabling/disabling paper autocutting at cover close
Paper width setting
Auto replacement of font
Print speed
Command execution (offline)
Specification for the top margin by backfeed
Optional external buzzer control
Interface setting
Communication conditions using a serial interface
Communication conditions using a USB interface
Interface switch wait time
Main interface selection
Enabling/disabling Display when interface is activating
Power supply capacity
Automatic line feed
Select paper sensor(s) to output paper-end signals
ERROR signal when an error occurs
For details on the memory switches and customized values, see
Follow the steps below.
1
After running a self-test, hold down the Feed button for at least one second to enter
the Mode selection.
The Mode selection guidance is printed, and the Paper LED flashes.
2
Briefly press the Feed button three times (less than one second), hold it down for at
least one second to enter the Software settings mode (Customized value setting).
The Software setting mode guidance is printed, and the Paper LED flashes.
72
"Software Settings" on page
59.