Inserting The Slip Paper - Epson TM-H6000IV-DT Technical Reference Manual

Inserting the Slip Paper

When printing on the slip paper, follow the steps below to insert the slip paper.
MICR reading is available by inserting the paper so that the MICR characters on the paper are on the right side.
• Do not insert any paper that has clips or staples. This may cause paper jams and damage.
• Make sure the slip paper is flat, without curls, folds, or wrinkles.
• For MICR reading, use the slip paper of 12 cm {4.72"} long or more.
1
Turn on the product.
2
Insert the slip paper face up with the right paper edge against the right side of the
paper guide, and insert it as far as it will go.
3
Insert the paper straight until the top edge of the paper touches the stopper.
4
When the product starts feeding the paper, release it immediately.
5
Remove the ejected paper by pulling it straight up out of the product.
Chapter 2 Printer Functions and Settings
2
41