Table of Contents
Advertisement
Software Setting Mode
Set the printer's memory switches and customized values.
• Print density
• Auto reduction of amount of paper to use
• Enabling/disabling paper autocutting at cover close
• Paper width setting
• Auto replacement of font
• Print speed
• Specification for the top margin by backfeed
For details on the memory switches and customized values, see
Follow the steps below.
1
After running a self-test, hold down the Feed button for at least one second to enter
the Mode selection.
The Mode selection guidance is printed, and the Paper LED flashes.
2
Briefly press the Feed button three times (less than one second), hold it down for at
least one second to enter the Software settings mode (Customize Value Settings).
The Software setting mode guidance is printed, and the Paper LED flashes.
Customize Value Settings
Modes
0: Exit
1: Print Current Settings
2: Print Density
3: Print Speed
4: Automatic Paper Reduction
5: Auto Paper Feed&Cut at cover close
6: Paper Width
7: Top Margin
8: Character/Font Settings
10: Interface Settings
12: Command Execution (Offline)
14: Other Settings
Select Modes by executing following
procedure.
step 1. Press the Feed button less
than 1 second as many times
as the selected mode number.
step 2. Press Feed button for 1
second or more.
Chapter 3 Printer Functions and Settings
"Software Settings" on page
41.
3
49
Advertisement
Table of Contents
