Inserting Slip Paper - Epson TM-J7200 Technical Reference Manual

Inserting Slip Paper

Follow the procedure below to insert slip paper:
1
Make sure the printer is turned on.
2
Set the paper so that the right edge of the paper contacts the paper guide on the
right and insert the slip paper. Refer to the label affixed to the printer.
➀
TM-J7200
3
The Cut sheet LED turns on when slip paper is being printed. After printing has been
completed and the slip paper has been discharged, the Cut sheet LED repeats a dou-
ble-flashing pattern.
 Be sure the paper is flat, without curls, folds, or wrinkles.
 Use only single sheet paper. Do not insert any multiple sheet paper, as this may cause a paper
jam.
 Pressure sensitive copy paper cannot be used because the printer is an inkjet printer.
 Roll paper must be installed evenly for printing on slip paper in order to prevent paper jams.
Confirm that the Cut sheet LED is turned off or flashing continuously when inserting slip paper.
➁
If the next print data is sent before printed paper is removed, the printer goes offline, causing the
Error LED to turn on.
Chapter 5 Handling
➀
➁
TM-J7700
5
73