Display And Keypad - Badger Meter Data Industrial 3000 Series User Manual

DISPLAY AND KEYPAD

The Series 3000 flow monitor has a two line by 16-character display with two modes of operation and 5 keys on the front
panel for programming .
Menu 1-Switch to main menu
2-Backward/Previous menu
Enter 1-Save value
2-Forward/Next menu
When the Series 3000 flow monitor is first powered up, it runs through internal self checks while displaying "Badger Meter
DIC Initializing." At the end of this cycle its normal mode display will appear .
In the normal mode, if still using the factory defaults, flow rate will be displayed on the top line, and flow total displayed on
the bottom . Both lines can be custom-defined in the field as desired . In the normal mode the Enter key has no function .
The other mode is the program mode, used to configure the unit . Press Menu to enter and exit this mode . See
Flowchart—Software Version 1.2.29" on page
April 2017
Up Arrow 1-Select Menu option
2-Increase numerical value
Down 1-Select Menu option
Arrow
2-Decrease numerical value
Right 1-Select Menu option
Arrow
2-Move cursor to the right
0.0 GPM
0.0 gal
Menu Enter
Figure 14: Normal mode display
13 .
RESET SETUP DIAG
Menu Enter
Figure 15: Program mode display
DSY-UM-01667-EN-05
Display and Keypad
"Programming
Page 11