Table of Contents
Advertisement
INTRODUCTION
The Badger Meter® Data Industrial® Series 3000 flow monitor is an economical, full featured, digital flow monitor .
The two-line × 16-character alphanumeric display can be configured by the user to display flow rate and flow total . The panel
meter has a NEMA 4X rated front panel and conforms to DIN Standard dimensions, 96 mm × 96 mm, for meter sizes and panel
cutouts . An optional NEMA 4 wall mount is also available .
The Series 3000 flow monitor accepts pulse, sine wave or linear analog input signals . Like all Data Industrial flow monitors, the
Series 3000 flow monitor may be field calibrated by the user . For Data Industrial sensors "K" and "offset" numbers are entered,
while other pulse or frequency output sensors may use a K-factor only . Analog inputs are fully programmable for slope
and intercept .
SAFETY INFORMATION
The installation of the flow monitor must comply with all applicable federal, state, and local rules, regulations, and codes .
Failure to read and follow these instructions can lead to misapplication or misuse of the flow monitor, resulting in personal
injury and damage to equipment .
UNPACKING & INSPECTION
Upon opening the shipping container, visually inspect the product and applicable accessories for any physical damage such
as scratches, loose or broken parts, or any other sign of damage that may have occurred during shipment .
N
OTEE:
If damage is found, request an inspection by the carrier's agent within 48 hours of delivery and file a claim with the
carrier . A claim for equipment damage in transit is the sole responsibility of the purchaser .
PROGRAMMING THE SERIES 3000 FLOW MONITOR
Programming is menu driven . All data is entered using the LCD/keypad interface . A password gate is included to prevent
unauthorized access to programming parameters . Programming flexibility is extended to units of measure . In addition to
several factory units of measure, the Series 3000 flow monitor software permits the custom units for rate and total to be
created by the installer .
The Series 3000 flow monitor provides one Form C solid-state relay, and one solid-state switch output . Both are fully
programmable as either pulse/volume, or setpoint control . For pulse output, the installer can program both the resolution
and the pulse width . Setpoint control is extremely versatile with fully independent set and release points, each with its own
time delay .
Options
•
Analog output
•
Analog input
•
Single flow channel input
•
One control relay output
•
One programmable pulse output
•
Low voltage AC/DC supply
•
USB
•
RS485 w\BACnet™ or Modbus® protocols
•
Wall mounting
April 2017
DSY-UM-01667-EN-05
Introduction
Page 3
Hide quick links:
Advertisement
Table of Contents
