Epilog Laser FusionPro 32 Original Instructions Manual page 78

SECTION 6: CONTROL PANEL
• Saved jobs will always be visible at the top of the list with a save icon next to the job name.
• Pressing and holding down your finger on a job will pull up the job's settings, allowing
you to view the Speed, Power, and Resolution or Frequency. A save button will also be
visible in the upper right corner that allows you to save the job permanently to the laser.
Speed
This icon indicates the speed settings on the selected job. It ranges from 1-100%.
Power
This icon indicates the power settings on the selected job. It ranges from 1-100%.
DPI
This icon indicates the resolution settings on the selected job. It ranges from 75-1200.
Frequency
This icon indicates the frequency settings on the selected job. It ranges from 1-100%.
Delete Button
The Delete Button will permanently erase jobs from the Job Menu. To
delete a job, select the job in the Job Menu, and then select the Delete
Button. A dialog will pop up to confirm that you want to delete the file.
Select "Yes" and the file will be removed from the Job Menu.
Note: If you have marked a job as "Saved" and delete the
file, it will still be erased from the Job Menu.
- 74 -
Job-1
Are you sure you want to delete this le?
Yes
Idle
No