Table of Contents
Advertisement
SECTION 6: CONTROL PANEL
Jog Menu
Access the Jog Menu by pressing the Jog key, which will turn green
when active. The Jog Menu allows you to adjust the current X and Y axis
Jog Axis
positions of the laser head. You may change the current position of the
(inches)
laser head either using the Joystick, or by entering precise coordinates.
The Nudge arrows allow you to fine-tune the position down to a
Current Position
Nudge Amount:
0.005
thousandth of an inch. Once you are finished using the Jog Menu, press
X:1.000
Y:1.000
the Jog key again to return to the main Job Menu. Press the Reset key to
< >
return the laser back to its home position.
Move To
Move
X:
0.0
Y:
0.0
Auto Focus
Auto Focus
When you have jogged the lens carriage above your material, press
the Auto Focus button to use the pluger Auto Focus. The table will rise
until the material touches the plunger, then set the table to the correct
height. Your job should now be in focus.
Done
Jogging
Focus Menu
To access the Focus Menu press the Focus key, which turns green when
Focus Menu
active. The Focus Menu is used for raising or lowering the table level to
(inches)
focus the laser precisely to your engraving or cutting material using the
Current Focus
0.000
Focus Gauge. The height of the table is adjustable by either using the
joystick, or using the Nudge arrows to fine-tune the height down to a
Move Table
Nudge Table:
0.0
0.005
thousandth of an inch. Once you are finished using the Focus Menu,
Focus
press the Focus key again to return to the main Job menu.
Home Table
Home Table
Pressing the Home Table button resets the table height to its home
position, which is the default every time you turn on the machine.
Done
Idle
- 76 -
Advertisement
Table of Contents
