Table of Contents
Advertisement
SECTION 9: OPTIONAL FEATURES
Fusion Pro Rim-Drive Rotary Attachment
The optional Fusion Pro Rim-Drive Rotary Attachment allows you to mark and engrave on cylindrical
objects.
Rotary Attachment Installation
1.
Lower the engraving table far enough so the Rotary Attachment will not interfere with the lens
carriage.
An important note: Turn off the power to the engraver. It's important that the laser system is
turned off before installing (or removing) the Rotary Attachment.
2. Place the Rotary Attachment in the upper left corner
of the table so that the baseplate is positioned
against the sides of the left and top rulers. The rotary
rests on the table against the rulers and does not
need to be locked in place.
3. With the Fusion Pro powered off, mate the cable
connector to the plug located at the right side of the
cabinet as shown in the photo.
4. Once the Rotary Attachment cable is connected, you can power on the laser system. The Fusion
Pro senses that the Rotary has been installed. During machine initialization the lens carriage will
find its new Home Position over the center of the Rotary Attachment, as shown below.
- 98 -
Advertisement
Table of Contents
