Table of Contents
Advertisement
SECTION 6: CONTROL PANEL
•
Pressing the Go/Stop button during a running job will stop the lens carriage and the laser beam
will be shut off. If the Go/Stop button is pressed during raster engraving mode the lens carriage will
pause on either the far left or far right of the engraving line that is in process. If the Go/Stop button
is pressed while in vector cutting mode, the lens carriage will stop at the end of a line segment or at
the next line node location.
•
Once the lens carriage has stopped, you can open the door to examine the job. By closing the
door and pressing the Go/Stop button, the job will commence where it left off. If the item being
engraved/cut has not been moved, the engraving/cutting registration will not be affected.
•
Note: Opening the door on the laser during engraving or cutting will stop the laser from
firing; however, the lens carriage will continue to move. It is important to stop the job
before you open the door to ensure the engraving/cutting is completed.
•
If you press the Go/Stop button while in vector mode it may take some time for the system to
actually stop. The system needs to get to the next node in a vector before it can stop.
LED Status
The ring around the Go/Stop button will change certain colors depending on the Fusion Pro's status.
•
White: The machine is booting.
•
Purple: The machine is waiting for the touch screen configuration to load.
•
Multi-colored: The machine is Homing.
•
Alternating Light Blue to Green: Machine is Idle and ready to run a job.
•
Green: Machine is actively running or tracing a job.
•
Red: A drive has failed. The number of flashes determines the drive number that failed. If more than
one drive has failed, it flashes for the first sequential drive.
•
1 - X Axis
•
2 - Y Left Axis
•
3 - Y Right Axis
Reset Key
•
Pressing the Reset key will move the carriage back to its Home Position. Press the Reset
key after you have moved the carriage when in Jog mode.
•
You may also press this key if you want to start a job over after pausing it with the Go/
Stop button. Reset does not erase the job from the laser systems memory; rather it will
stop the engraving job in process and send the carriage back to the Home Position.
Focus
The Focus function allows you to manually set the table to the correct height for engraving
while using the Focus Gauge. With Focus highlighted, use the Joystick to move the table up
or down. The display will show a digital readout of the table position. Press once to enable
the Focus feature and the icon will turn green. Press again to exit this feature.
- 72 -
Advertisement
Table of Contents
