Table of Contents
Advertisement
APPENDIX C: SYSTEM CALIBRATION
5. Follow the prompt and close the lid on the
engraver. Once OK is pressed the laser will
start engraving the calibration pattern. The
engraver will automatically focus to the
0.025" thickness of the anodized aluminum,
the engrave a calibration pattern.
Close the door and press the OK button to run the
calibration job.
More instructions will automatically appear once
the job is running.
Ok
Idle
6. Allow the job to run until completion.
The job is currently running.
Once complete, the calibration will continue
automatically and the carriage will begin moving.
Idle
Cancel
Cancel
7.
Once the job has finished engraving, the
camera at the laser head will take pictures
of the engraving to calibrate itself. This
process takes several minutes.
Please wait while the calibration routine is in
progress. Press cancel at any time to abort the
process.
Idle
- 143 -
Cancel
Advertisement
Table of Contents
