Epilog Laser FusionPro 32 Original Instructions Manual page 79

SECTION 6: CONTROL PANEL
Settings/Config Menu
The Settings/Config menu has two sub-menus, System and Network Settings.
System
Once selected, the System Settings display detailed information about the machine. These are factory
settings that should not be changed unless instructed by Epilog Technical Support.
Network
Once selected, the Network Settings allow you to change the IP Address and the Netmask. The IP Address
on this screen should match the IP Address you have assigned your machine in the Job Manager. If you
have multiple machines, each one will need it's own IP Address. For more information, see "6. Set the
Fusion Pro's IP Address" on page 18.
Park Axis
Pressing Park Axis returns the Laser to the Home Position.
Home Axis
Pressing Home Axis repeats the Homing process that happens when the machine powers on.
Home Table
Home Table resets the table height to its Home Position.
Settings
+
System
+
Network
Park Axis Home Axis Home Table
Idle
- 75 -