Table of Contents
Advertisement
SECTION 2: GETTING STARTED
Epilog Exhaust/Filter Connections
There are two 4" (102 mm) ports attached to the back of the Fusion Pro 32 laser system, and three 4" (102
mm) ports attached to the back of the Fusion Pro 48 laser system. Attach your ducting to the machine as
shown in the diagram.
Roof or Exterior Wall
4" (102 mm) flexible
aluminum duct or
rigid galvanized
sheet metal (do
not use vinyl,
plastic or "soft"
flexible duct).
Check your exhaust system for leaks. Most small leaks can be remedied with duct tape.
DO NOT OPERATE your laser with inadequate or leaking exhaust.
The drawings above show the typical exhaust setup. The left drawing shows the exhaust near the
machine and the right drawing shows the exhaust fan on the roof. Where the exhaust fan is placed is a
choice of personal preference. Some users like the exhaust fan outside because of noise considerations.
Exhaust Blower
- 16 -
Exhaust Blower
Roof or Exterior Wall
4" (102 mm) flexible aluminum
duct or rigid galvanized sheet
metal (do not use vinyl, plastic
or "soft" flexible duct).
Advertisement
Table of Contents
