Table of Contents
Advertisement
SECTION 8: SYSTEM FEATURES
Emergency Stop Button
On the top of the laser you will see a large, red Emergency Stop
key. If there is an emergency, such as a fire, immediately press the
Emergency Stop Button. The laser carriage will immediately stop
and the system will shut down.
To reset the system, you must turn off the system using the Key
switch, then twist the Emergency Stop Button clockwise to release
the system, then turn on the laser.
If your laser ever stops running and you can't turn it on, check to see if the Emergency Stop
Button has been pressed by accident.
Front Access Door
The front access door will open up to 180 degrees,
and is usually used for easy loading and unloading of
palletized materials. The door is interlocked and the
laser will not fire if the door is open.
Task Plate/Vacuum Hold-Down Table
Task Plate
On the Fusion Pro, the task plate is used as the
standard engraving table for jobs that do not include
vector cutting. The task plate is stainless steel and
allows you to use magnets to hold oddly shaped
items in place. On the Fusion Pro 48 there are two
taskplates, allowing you the option to split your
table to both engrave and cut materials in the same
process with a Vector Grid or Slat Table.
- 94 -
Advertisement
Table of Contents
