Table of Contents
Advertisement
APPENDIX C: SYSTEM CALIBRATION
Camera Calibration
Note: Before beginning, reboot your
machine if you have recently run any
jobs.
1.
Click the settings icon to enter the settings
menu
Idle
2. Long Press the "Settings" text for 5 seconds to
enter the advanced settings menu
Settings
+
System
+
Network
Park Axis
Idle
Home Axis
Home Table
3. Click on "Calibrate Cameras" to enter the
camera calibration menu
Idle
4. While the machine is Idle, follow the prompt,
and begin the calibration routine by
selecting "Ok". The calibration pattern
mentioned in the prompt will be used by the
single camera at the laser head. You can
optionally skip this step by clicking Skip. You
must use an 8 x 5 inch or larger piece of
anodized aluminum.
This calibration routine requires you to engrave a
calibration pattern onto black anodized aluminum.
Before proceeding, place a 8" x 5" (200 x 125 mm)
piece of anodized aluminum in the upper left
corner of the machine. Ensure that the material is
flat on the machine bed.
Click OK when the material has been loaded into
the machine.
Ok
Idle
- 142 -
Settings
Calibrate Joystick
Alignment
Focus Commands
Calibrate Cameras
Diagnostics
Setup
Cancel
Skip
Advertisement
Table of Contents
