Table of Contents
Advertisement
SECTION 9: OPTIONAL FEATURES
9.
Crop the Photo: If you do not want to
engrave the entire photo, double click on the
photo to open the bitmap tools at the top of
the page. Select the Rectangle or Ellipse tool
to frame the area you want to crop. With the
proper area framed, press the Crop key to
finalize the crop.
10. Resize the Photo: You must now resize the
photo to the size you want to engrave. With
the photo selected, type in the X and Y
dimensions of the photo.
11. Set the Resolution: This number must match
the resolution at which you will be engraving
the photo. Select Image then Image Size
from the menu. Type in the resolution and
select Apply.
Make sure you have selected Apply
or the new resolution will not be
saved with the image.
12. Transform the Photo: With the photo resized
and the resolution set, we are ready to
transform the photograph. From the menu
select Transform then Photo Laser. Choose
Interactive to select the material you want to
use. Choosing Automatic will apply the
material settings you used on your last
project.
13. Select the yellow folder to open the materials
folder.
14. Choose the material you are going to
engrave. If you don't see the Epilog settings,
they can be downloaded from
com/photolaserplus_instructions.htm.
- 106 -
epiloglaser.
Advertisement
Table of Contents
