Outdoor (cabinet - mount) GAP installation
Outdoor (cabinet - mount) GAP installation
■
■
■
■
■
■
■
■
■
■
■
■
■
■
This section provides general information to install the Ground - based Access Point (GAP) in an
outdoor environment. Each customer installation will vary. All outdoor GAP installations require
the use of a 5 - ft by 7 - ft concrete slab capable of supporting one ton (2000 lbs or 900 kg). Side
- by - side cabinets will require the use of two 5 - ft by 7 - ft concrete slabs.
GAP cabinets
The GAP cabinet comes pre-loaded with hardware cages. Cards, modules, and batteries are
installed separately in the GAP cages after the main mounting to a concrete or other support (re
- enforced floor) surface. Installation of the cards, modules, and batteries are customer site
dependent, and are not specifically covered in this manual.
5-2
■
■
■
■
■
■
■
■
■
■
■
■
■
The GAP cabinets are heavy. The use of a crane and / or hoisting system that is rated
to handle at least two tons (4000 lbs or 1800 kg) is recommended. A four-point
hoisting cable with appropriate hooks or carabiners should be used to unload the GAP
cabinet from the shipping pallet to the area of nal installation.
PRELIMINARY - UNDER DEVELOPMENT
■
■
■
■
■
■
■
■
■
■
■
■
■
■
Chapter 5: Outdoor GAP Hardware Installation
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
68P09286A73-1
JUL 2007