Wall Mount Installation - Motorola AP-6511 Installation Manual

10
• Ensure the cable length from the Ethernet source (host) to the Power Injector and AP-6511 Access Point
does not exceed 100 meters (333 ft).
CAUTION
CAUTION

2.5 Wall Mount Installation

Ceiling mount requires holding the AP-6511 Access Point up against a T-bar of a suspended ceiling grid and twisting
the case onto the T-bar.
NOTE
To install an AP-6511 model Access Point to a wall surface:
1. Attach the metal mounting plate (shipped with the AP-6511) to a wall surface at the desired deployment
location.
The screws used to mount the bracket are customer provided and should be #6, with a 2.00 inch length.
To avoid problematic performance and restarts, disable POE from a
wired controller port connected to an Access Point if mid-span power
sourcing equipment (PSE) is used between the two, regardless of the
manufacturer.
Ensure AC power is supplied to the Power Injector using an AC cable
with an appropriate ground connection approved for the country of
operation.
Motorola Solutions recommends the following customer supplied
mounting accessories an AP-6511 wall mount installation:
2, screws, #6 x 2.00 inch pan head
2, wall anchors suitable for the #6 screws
AP-6511 Access Point